HyHaven Bed Drive Systems
Electric drive systems for nursing and hospital beds
Actuators, control boxes and handsets that are designed to work as one system — specified for bed manufacturers, refurbishers and care-equipment builders, and sold as standard components you can order today.
One bed, one matched system
A powered bed fails in the details: an actuator the control box cannot drive, a handset that does not speak to the box, a function with no actuator assigned to it. The HyHaven bed range is built the other way round — two complete drive systems, each with its actuators, control box and handset matched at the factory, and every component stocked as a standard product you can reorder one-for-one.
System One
Five-function nursing bed
The full-care configuration. Four HH-LA-U9 / U10 actuators work under the HH-CB-M07 control box and HH-HC-H07 handset to run the five functions a nursing bed lives on:
- Back lift
- Leg lift
- Turn over (left / right)
- Toilet lift
- Stand-up assist
The M07 is a dedicated medical-bed control box: five actuator sockets with defined pin layouts, a built-in fuse, and voice prompts that the H07 handset can switch on or off. The H07 carries 14 keys, including the turn-over and toilet functions and a dedicated emergency-stop key.
The control logic links the functions, so the bed's sections move together without fighting each other. Where hand-crank lowering after a power cut is a requirement, specify HH-LA-U9-2 actuators for the set.
Actuators from $99.99 each · M07 $69.99 · H07 $29.99 — components are priced individually; message us for a complete-set quote.
System Two
Hospital bed, wide-voltage
The export configuration. The HH-CB-M03 control box accepts 110–240V AC input — one box for both 110V and 220V grids — and drives up to four HH-LA-U9 / U10 actuators at 29V DC, paired with the HH-HC-H05 handset (up to 10 keys, rated up to IP66).
The same system, with three or four actuators, is the standard drive for electric beauty and treatment beds. With the low-profile HH-LA-U4 (below), it also drives treatment chairs and examination tables.
Actuators from $99.99 each · M03 $59.99 · H05 $24.99 — components are priced individually; message us for a complete-set quote.
The two systems, side by side
| System One — five-function nursing bed | System Two — wide-voltage hospital bed | |
|---|---|---|
| Control box | HH-CB-M07 | HH-CB-M03 |
| Mains input | AC 220V only | AC 110–240V |
| Output | DC 24V, five defined sockets | DC 29V, up to four actuators |
| Actuators | 4× HH-LA-U9 / U10 (U9-2 where hand-crank lowering is required) | Up to 4× HH-LA-U9 / U10, or HH-LA-U4 for chairs |
| Handset | HH-HC-H07 — 14 keys, voice prompts, emergency stop | HH-HC-H05 — up to 10 keys, up to IP66 |
| Best for | Full-care nursing beds in 220V markets | Export hospital, beauty and treatment beds on either grid |
At the centre of both systems
HH-LA-U9 / U10 — 6,000 N bed actuators
Both systems are built around the same actuator: 6,000 N push force, 4 mm/s under load, 24V DC, built-in limit switches, IP54 sealing and a 10% duty cycle rated for the short, frequent movements of bed positioning. Seven stocked stroke lengths from 100 to 400 mm cover standard bed frames; longer strokes are built as custom orders. Every actuator carries a 12-month warranty.
The low-profile actuator
HH-LA-U4 — built low, for chairs and tight frames
Not every drive point has room for an inline actuator. The U4 mounts its motor sideways in an L-form body with a low built-in height, so it fits where space runs out first: under treatment and dental chairs, inside examination tables, and beneath the low decks of care beds, driving the back and leg sections.
It is not a light-duty compromise: 6,000 N push, 4,000 N pull, a 6,000 N self-locking force and a stainless-steel inner tube, run by the same M02 and M03 control boxes as System Two — a single U4 on an M02 is the standard drive for a powered treatment chair.
Safety is a component, not an accessory
Emergency stop
The HH-ES-01 cuts actuator power instantly (push to lock, twist to release) and works with the M02, M03 and M07 control boxes. The H07 handset also carries its own emergency-stop key.
Power failure
The HH-LA-U9-2 adds a manual crank release to the standard actuator, so staff can lower a bed section by hand when the power is out.
Overload protection
Built into the M02, M03 and M07 control boxes, between your actuators and the mains. On the five-function nursing-bed system, protection also cuts in if the bed is loaded past its rating.
Defined travel
Every bed actuator has built-in limit switches at both ends of its stroke.
Where these systems run
Nursing beds
Five-function care beds for facilities and home care: System One.
Hospital beds
Multi-function ward beds on either grid voltage: System Two.
Beauty & treatment beds
Three- and four-actuator lifting and tilting: System Two.
Treatment & dental chairs
And examination tables — low-profile drives where an inline actuator does not fit: HH-LA-U4 on System Two.
Home care beds
The same nursing-bed systems, sized and priced for home-care builds: System One or Two.
Patient hoists & mobility aids
Compact drives for lifting and repositioning equipment: HH-LA-U4 and U9.
Every part of the system, priced and stocked
Actuators and controllers are sold separately — buy a full system, or replace a single part in a bed you already run.
HyHaven HH-LA-U9 Linear Actuator
6,000 N bed actuator, 24V, 100–400 mm
from $99.99
HyHaven HH-LA-U10 Linear Actuator
6,000 N bed actuator, 24V, 100–400 mm
from $99.99
HyHaven HH-LA-U9-2 Linear Actuator with Manual Crank Release
The U9 with a manual crank release for power failures
from $109.99
HyHaven HH-LA-U4 Linear Actuator
Low-profile L-form actuator, 6,000 N, for chairs and tight bed frames
from $99.99
HyHaven HH-CB-M07 Medical Bed Control Box
Five-function medical-bed control box, AC 220V in / DC 24V out
$69.99
HyHaven HH-CB-M03 Control Box for Linear Actuators
Control box for 1–4 actuators, 110–240V in / 29V out
$59.99
HyHaven HH-CB-M02 Control Box for Linear Actuators
Control box for 1–2 actuators, 110–240V in / 29V out
$49.99
HyHaven HH-HC-H07 Medical Bed Handset Controller
Medical-bed handset, 14 keys, pairs with the M07
$29.99
HyHaven HH-HC-H05 Handset Controller
Handset for up to 5 actuators, pairs with the M03
$24.99
HyHaven HH-FS-01 Foot Switch Controller
Foot switch, pairs with M02 / M03
$19.99
HyHaven HH-ES-01 Emergency Stop Switch
Emergency stop switch, 10A, push-lock / twist-release
$39.99
Set hardware, specified with your order
A finished bed needs more than actuators and a control box. The drive family behind this page is supplied with the small hardware a set actually installs with — specified per order and confirmed on your quote, so what arrives matches your market and your frame:
- Regional power cords — CN, EU, US and UK plugs for the control boxes
- Splitter cables — one-to-two leads for paired actuator runs
- Mounting pins and brackets — the pins and seats the actuators bolt to
- Hand crank — supplied with HH-LA-U9-2 manual-release sets
Hardware is not sold separately on this page; it is part of a set configuration. Tell us your market and frame when you write, and we confirm the hardware list with the quote.
Built to your frame, not just stocked
The stocked range covers standard beds. For production runs, the same drive family is built to order:
Stroke lengths
U9 / U10 strokes beyond the stocked 100–400 mm are built as custom orders.
Finish
Black or grey-white housings across the bed actuator range.
Cables & plugs
Plugs and cable configurations set per order, for your market and frame.
Questions
Can I buy a complete bed system as one set?
Yes. Sets are quoted per configuration rather than listed at a fixed price — send us the bed's functions and frame dimensions and we will confirm the actuator strokes, control box and handset as one quote.
My grid is 110V. Which system do I need?
System Two. The M03 control box accepts 110–240V input. System One's M07 box is AC 220V only.
Can I mix parts between the two systems?
No — and that is deliberate. System One runs on the M07's 24V multi-pin sockets; System Two runs on the 29V control system. Parts are matched inside each system so a bed cannot be wired into a combination the control box was not built for.
What warranty do the actuators carry?
12 months against defects in materials and workmanship. To claim, email support@hyhavenstore.com with your order number.
How fast can you ship?
Stocked components leave our Wenzhou warehouse in 1–2 business days; air delivery takes 5–8 business days. Custom strokes and set builds are confirmed per order.
Building or refurbishing powered beds?
Send us the bed type, the functions you need and the frame dimensions you are working with. We will confirm the right system — actuators, control box and handset — before you order.
support@hyhavenstore.com · WhatsApp +86 139 5881 4345